Alignment Tools & Adjustment Kits

SPC 23236: 1-1/2° FORD SLEEVE   SKU: 23236   This truck sleeve will correct caster and camber ±1.50° on trucks equipped with the Dana Super 60 solid axle, such as the F450, F550 and GM Topkick. Other sleeve sizes are also available, see below...

These sleeves make installation of Offset Ball Joints easy for the installer. The sleeves are designed to match the angle of the yoke on the axle housing to insure proper installation. Sleeve set #23780 is for our Dodge Truck Offset Ball Joints (part nos...

For use on most cars and some light trucks. The tapered wedge easily removes the pitman arm from the shaft with just a few sharp hammer blows.   DIMENSIONS: 1" opening, 12" overall length.

Five tools in one, this handy kit consists of three drop forged forks and two handles. One handle is for use with a hammer and one is designed to fit an air hammer. All forks are threaded to interchange with either handle. Comes with 3 forks of 11/16",...

Expand the service capability of your ball joint press with this Master Ball Joint Adapter Set. This complete kit includes the adapters and receiving tubes needed to work on GM, Ford and Dodge two and four wheel drive trucks, vans and SUVs. Kit also...

Thin walled spanner wrench designed specifically for installation and removal of O.E. and #23000 screw in 4WD alignment sleeves.   CAUTION: Not for use with impact wrenches (air tools).

This wrench makes it easy to adjust the control arm cams on many modern GM and Chevy HD Trucks along with the new Colorado and Canyon. The tool surrounds the entire perimeter of each cam to provide a solid no slip means to reach the hard-to-reach and...

This angle gauge is an easy, accurate way for measuring frame and drive shaft angles. An ideal tool to ensure the drive line angle is still within specification for raised and lowered vehicles. Alignment equipment manufacturers are using frame angle...

Previously 7190 Tie Rod Tool Kit. This kit includes part numbers 71959 through 71999. It will allow adjustment of most cars and light trucks and also includes the 2 larger adjusting tools needed for the new Ford Super Duty pickups. Tools have a 1/2"...

Center Punch Stud for SPC 74910 Cam Knockout Punch.

An adjustable steel plate extends the length of the bar to put constant pressure on the brake pedal.